GUIDES
CONTENTS
1. How to measure and install a window sill
2. How to order a bathroom countertop
3. Should the windowsill cover the radiator?
4. Which corner sofas should I choose?
5. Care of granite, marble and conglomerates (material properties)
6. What is a conglomerate (material properties)?
7. Conglomerates for kitchen and bathroom countertops (material properties)
1. How to measure and install a window sill
Below we present a short guide on how to correctly measure the window sill inside and outside the building so that the installation does not cause problems and the window sills made of conglomerate, granite or marble look aesthetic and fulfil their functions.
By following the tips below you can achieve the ideal proportions of the window sill, and thus its aesthetic appearance:
– a properly installed window sill must be recessed into the sides of the wall (rails) by a minimum of 3 cm and a window sill with a decorative cutter by a minimum of 5 cm
– we assume 0.5 to 1.5 cm under the window sill
– the window sill should protrude 3 to 5 cm outside the wall
– the window sill should be installed with white glue or low-pressure foam
For example:
the window opening is 150 cm long and 20 cm deep, the window sill should measure 156 cm x 25 cm, and the window sill with a decorative cutter should measure 160 cm x 25 cm.
2. How to order a bathroom countertop
- click on the photo of the bathroom countertop to open the page about the selected countertop,
- select the type of corners,
- enter the length and width of the countertop to determine its price,
- make a sketch where we should make holes for the tap and washbasins, and add it by clicking "choose file",
- add the countertop to the cart and click the "continue shopping" button to return to configuring the countertop,
- scroll down the page and click on "bathroom countertop accessories",
- select the type and number of holes for sinks and taps, and then click “add to cart”,
- maintain a minimum distance of 6 cm from the sink hole to the edge of the countertop (sketch below),
- now you are ready :)
3. Should the windowsill cover the radiator?
If the window sill completely covers the entire radiator, what is the minimum distance between the bottom of the windowsill and the top of the radiator? The minimum upper distance is 10 cm (fig). It can ultimately be reduced to 7 cm, but this requires increasing the thermal efficiency of the radiator by 10%. If the distance is less than 7 cm, the window sill should not cover the radiator.
4. Which corner sofas should I choose?
The choice of the window sill corners depends on the customer's preferences. The corner type has no impact on the use of window sills. Each window sill has a polished surface, with 3 sides being polished and their edges slightly bevelled, while one side on the window side is always raw. Standard sides are polished to approximately 10 cm. Straight or rounded corners? Choose the type you like more.
Rounded corner:
Straight corner:
5. Care of granite, marble and conglomerates (material properties)
Granite:
Clean with a microfiber cloth and water, neutral pH detergent or dishwashing liquid. Remember to always test the product on an invisible part of the granite. Make vertical movements, never circular ones. Do not use rough cloths and brushes. In the case of granite, it is also prohibited to use agents with acidic or alkaline pH and cleaning agents for ceramic tiles.
Never use:
- Cleaning agents for ceramic tiles, as they may dull the granite surface.
- Sharp cloths and wire washers.
Marble:
Cleaning should be done with a microfiber cloth soaked in a small amount of water and dishwashing liquid or a special neutral pH agent. It is worth testing the effectiveness of the detergent on a small, inconspicuous fragment of marble. Do not rub the surface with anything abrasive. It is not recommended to make circular movements when cleaning. Never use:
- Cleaning agents for ceramic tiles, as they may dull the marble surface.
- All agents with an acidic or alkaline pH (e.g. vinegar).
- Sharp cloths and wire washers.
Conglomerates:
Soak a microfiber cloth with a small amount of water and a delicate dishwashing liquid or a special agent intended for cleaning conglomerates that have a neutral PH.
- Remember to test the detergent on a small, inconspicuous area before using it.
- Gently remove the stain by moving the cloth across the surface in a vertical motion, but never use the cloth in a circular motion!
- Remember not to rub the surface with anything abrasive!
Never use:
- Cleaning agents for ceramic tiles, as they may dull the conglomerate surface.
- All agents with an acidic or alkaline pH (e.g. vinegar).
- Sharp cloths and wire washers.
ATTENTION!
The natural surface of polished stone has micropores, their number and size depending on the characteristics of a given stone.
Fat (oils, butter, etc.) and strongly coloured food items left on the stone should be removed immediately.
Fats left on the stone can penetrate deep, up to 3 cm, depending on the structure and absorbency of the stone used,
while marble and marble conglomerates may additionally show semi-matt traces of use.
There are chemical cleaning and impregnation products available on the market that are applied to the stone and left for a reaction time of up to 8 hours.
These agents then neutralize the grease, leaving a clean stone that can be impregnated to prevent the problem from recurring.
Therefore, it is recommended to test the product in the conditions provided by the customer.
6. What is a conglomerate (material properties)?
The conglomerate is a material consisting of selected natural marble constituting 95% of the mass and 5% polyester resin as a binder.
Conglomerates are 95% marble and therefore have the same functional properties as natural marble. Their advantage is colour repeatability. Just like natural marble used outdoors, the conglomerate will become slightly matte over time, but this does not affect its usability and is a feature rather than a defect.
7. Conglomerates for kitchen and bathroom countertops (material properties)
The conglomerate is a material consisting of selected natural marble constituting 95% of the mass and 5% polyester resin as a binder. Their advantage is colour repeatability. Similarly to natural marble used for kitchen or bathroom countertops, the conglomerate will show slightly dull traces of use over time while traces of liquids with an acidic or alkaline pH may be visible on the surface, but this does not affect its usability and is a feature rather than a defect
